40 mm Fan Voltage:24 V and carriages purchased independently of

and carriages purchased independently of rails may not have the same fit as a paired rail and carriage

LCD Screen Setup Instructions-

1 - Atmega2560 microcontroller with on-board peripherals

the bed is then automatically leveled by adjusting the z-motors at each of the four corners

40 mm Fan Voltage:24 V and carriages purchased independently ofThis fan is the smaller of the two fans mounted in front of the extruder and is also used inside the electronics case. These fans have a keyed connector, guarding against incorrect plug in. All fans should be kept free of dust buildup to prevent failure. *M2 3D printers purchased in November 2015 or earlier require the 12 volt version of the 40 mm fanplease be sure to select the proper voltage based on your date of purchase. If you are unsure which